What Kind Of Battery Is In A Stanley FatMax? Isn’t it easy to use? With the jump starter in your trunk, you won’t need to beg other motorists to help you jumpstart your battery if it goes down. That’s all it takes to jumpstart your vehicle with this wonderful jumper. It is better to charge the jump starter overnight. But since you’ve just used it once, it may get charged sooner. Normally, it takes about 12 – 14 hours to charge the device from zero to 100%. Step 5 – Charge The Unitĭon’t forget to charge the jump starter when you get back home. Anything outside the temperature bracket will make the jump starter lose its charge. The best temperature for your jump starter is 50 – 70 degrees F. At the same time, if you live in a cold part, the trunk of your car may be too cold.
If you live in a very hot part of the country, the trunk of your car may be too hot. You can put the jump starter inside the trunk of your car, but be careful. Remove the jump starter and close the hood of your car. After that, you can disconnect the black clamp and then disconnect the red clamp. When you have been able to start your car, gently switch off the jump starter by turning the red knob 90 degrees counterclockwise. And if it starts, leave the car to run for about 15 to 20 minutes before you move. It should start at the first attempt, but if it doesn’t, don’t crank it longer than 5 seconds before you stop. When you get it right, you should get a beep of confirmation. If it does, swap the connections and you’re good. If you get it wrong, the alarm will go off immediately. Connect the red clamp to any terminal and the black to the second terminal. You’ll have to depend on the reverse polarity alarm. And it could also be labeled “P” or “POS.” Now, try to identify the positive battery terminal. A buildup of corrosion prevents the clamp from connecting firmly to the battery terminals. The red clamp is for the positive battery terminal and the other black clamp is for the negative battery terminal.īefore you connect the clamp, look at the battery terminals carefully for corrosion. You’ll observe that the device has two jumper cables and each of the ends with a clamp. Turn the knob 90-degrees in a clockwise direction. Look for a red knob at the lower right side of the front panel of the unit. Now, you can turn on the jumpstarting feature. The display unit will show the voltage the jump starter has. Then, you need to press the “battery” button. Place the jump starter somewhere flat and level to prevent it from dropping when you crank your engine. To jumpstart any vehicle, the first step is to open your hood, where you’ll see the battery. The level of its battery is indicated on the LCD display unit. However, you must charge it to 100% before you use it.
Stanley battery jump starters how to#
Stanley Fatmax Jump Starter Instructions: How To Use The Deviceīefore you do anything, you need to confirm that the jump starter is fully charged. So, the problem with the Toyota Prado SUV was a flat dead battery. Well, it jumpstarted other vehicles at the very first attempt. So, we were sure it would eventually start, and it did, at the third attempt.
It didn’t start at the second attempt either, but there was more life in the sound of the engine. At first, it roared and roared but didn’t start.
We tried it on a Toyota Prado SUV whose battery had been left for more than four months. When the battery is fully charged, this beast can jumpstart up to 40 vehicles before it gets weak. That way, it will only take a few minutes to charge. Charge the device after every jumpstarting session. The device takes about 12 to 14 hours to charge, and we think that’s a little too long. Well, there’s one little feature that we don’t like about it, and you may not like it either. Its yellow color makes it stand out in the crowd. On the other hand, if you connect the clamps the right way, you’ll get a beep of acknowledgment. While trying to jumpstart your battery, if you mistakenly connect the clamps to the wrong battery terminals, the reverse polarity alarm will go off. One safety feature that puts the Stanley Fatmax ahead of others is its reverse polarity alarm. In addition, you’ll love its handle, which makes it easy to carry the 10-pounder around.
Also, it has a display unit that shows the battery level and the pressure level of your car tires. There’s a very bright LED light to give you a clear view of what you’re doing at night.
0 kommentar(er)
